Changing The Batteries; Tapkey Smart Lock - Tapkey SMART LOCK Bedienungsanleitung

Third warning stage:
Engagement occurs immediately after presenting the
master or Programming Card. Once the transponder is
recognised, the low battery warning appears once. The
blue LEDs flash three times and engagement does not
occur.

CHANGING THE BATTERIES

Tapkey Smart Lock

Follow the steps below to change the battery:


Unlock the bayonet fitting using the knob tool and
carefully pull off the knob sleeve.
Fig. 18: Removing the knob sleeve
22
Caution: In the event of electrostatic discharge
(sparks or breakdown), electronic components
may be destroyed. For this reason, avoid elec-
trostatic charges prior to the (dis)assembly of
the knob sleeve or touch a conductive, groun-
ded object (e.g. water pipe, heating) before-
hand to remove electrostatic charge from your
body. Never touch the electronics components
with your fingers.
Please note: Only use the 3.0 Volt lithium
battery from Tapkey which is already pre-
assembled with the connection cable.
Pull the battery connector from the battery socket
and remove the old battery pack. (Make sure
you pull on the connector and the three cables at
the same time, not only on one or the cables.)
Fig. 19: Removing the battery
Insert a new battery.

Insert the battery connector into the battery socket.

Fig. 20: Inserting the battery
Place the knob tool on the bayonet fitting.
Slide the knob sleeve accurately over the electro-
nics holder. The knob sleeve can only be slid on in
one position. The two drive cams on the electronics
holder have different widths.
Fig. 21: Fitting the knob
Lock the bayonet fitting using the knob tool. Pre-
sent an authorised transponder in order to check
whether the cylinder is working perfectly after the
batteries have been changed.
Fig. 22: Locking the bayonet fitting
Please note: The battery connector has a torsi-
on-resistant guide lug.
Caution: Do not damage the battery cable
when fitting the knob.
23