Tapkey Padlock - Tapkey Smart Lock Bedienungsanleitung

Tapkey Padlock

Follow the steps below to change the battery:


Undo the Torx screws (Torx T10) and remove the
protective cap.
Fig. 23: Removing the protective cap
Unlock the bayonet fitting using the knob tool and
carefully pull off the knob sleeve.
Fig. 24: Removing the knob sleeve
24
Caution: In the event of electrostatic discharge
(sparks or breakdown), electronic components
may be destroyed. For this reason, avoid elec-
trostatic charges prior to the (dis)assembly of
the knob sleeve or touch a conductive, groun-
ded object (e.g. water pipe, heating) before-
hand to remove electrostatic charge from your
body. Never touch the electronics components
with your fingers.
Please note: Only use the 3.0 volt lithium
battery from Tapkey which is already pre-
assembled with the connection cable.
Pull the battery connector from the battery socket
and remove the old battery.
Fig. 25: Removing the battery
Insert a new battery.

Insert the battery connector into the battery socket.

Fig. 26: Inserting the battery
Place the knob tool on the bayonet fitting.
Slide the knob sleeve accurately over the electro-
nics holder. The knob sleeve can only be slid on in
one position. The two drive cams on the electronics
holder have different widths.
Fig. 27: Fitting the knob
Lock the bayonet fitting using the knob tool.
Fig. 28: Locking the bayonet fitting
Please note: The battery connector has a torsi-
on-resistant guide lug.
Caution: Do not damage the battery cable
when fitting the knob.
25