Petsafe Passport PPA00-13795 Montageanleitung Seite 14

5I.
If you are NOT using the exterior tunnel frame,
go to Step 5K. If your Wall Thickness (T) is
greater than 5 ⁄ " (149 mm), place exterior
7
8
tunnel frame (C-D) onto exterior pet door frame
with tabs in tunnel position listed in Chart 1 for
your wall thickness. Go to next step.
5J.
Using a ⁄ " (5 mm) drill bit, drill through side holes located
3
16
inside exterior tunnel frame through exterior pet door frame.
From inside of tunnel, push to insert a tunnel fastener into
each hole you just drilled until head of fastener is flush with
tunnel side.
Note: Small Model doors have 2 holes and Medium model
doors have 4 holes.
5K.
Apply duct tape along top
edge of interior and
exterior cut-out. Leave
approximately 2" (5 cm)
uncovered on either side of
tape and make sure no
excess tape will show
outside of pet door frame.
This is to cover raw edge of
cut-out to keep it from
pinching or cutting motion
sensor wire.
With motion sensor wire on
top of tunnel, place interior pet door frame in interior side of cut-out.
Helpful Tip: If working alone, tape interior frame in place while
installing exterior frame and installation hardware.
5l.
From exterior side of cut-out, plug motion sensor wire into
connector on exterior frame. Without pinching wire, guide any
excess wire into space between top edge of wall cut-out and
tunnel on exterior frame. Align exterior frame into cut-out. View
both sides to ensure the exterior and interior telescoping tunnels
are aligned.
14
5I
5K
www.petsafe.net
5J
5l
Inner
Tunnel
Outer