Conrad Electronic 75 11 57 Bedienungsanleitung Seite 35

d) Defining the channels for sequential display
Here you can set, which channels are to be played back in sequence.
Proceed as follows:
• Press and hold the button „PROG" (2) for 2 seconds to access programming mode.
• Now the LED „PROG" (D), the LED „ALM RESET/SEQ" (E) as well as the LEDs „CH1" to „CH4" (F,
G, H, I) light up.
• By pressing the buttons „CH1" to „CH4" (F, G, H, I) once, you can activate/deactivate the desired chan-
nel (activated = channel LED is red, deactivated = channel LED is off).
• To leave the programming mode, press and hold the button PROG (2) for 2 seconds.
Please note that the device exits programming mode automatically if there is no input
for 30 seconds.
35