Conrad Electronic 75 11 57 Bedienungsanleitung Seite 34

Channel 2 is displayed for 2 second
...etc.
Channel 1 and 2 are displayed alternating each 2 seconds.
After 30 seconds, channel 3 is displayed, then channel 4.
To terminate the alarm mode, press and hold the button „ALM RESET/SEQ" (3) once.
Option B
With this option, only the channels signalling an alarm are displayed.
Example:
If an alarm is detected on channel 1 and channel 2, the display would be as follows:
Channel 1 is displayed for 2 seconds
Channel 2 is displayed for 2 seconds
Channel 1 is displayed for 2 seconds
Channel 2 is displayed for 2 seconds
...With this type of option, the alternating display of both channels takes place in an endless loop.
To terminate the alarm mode, press and hold the button „ALM RESET/SEQ" (3) once.
c) Activating and deactivating the alarm inputs for individual video
channels
You can set for which video input you want to activate or deactivate the alarm inputs.
Please note that this requires the corresponding assignment of the alarm inputs as
described in chapter 13.
Please proceed as follows.
• Press and hold the button „PROG" (2) for 2 seconds to access programming mode.
• Now the LED „PROG" (D), the LED „ALM RESET/SEQ" (E) as well as the LEDs „CH1" to „CH4" (F,
G, H, I) light up.
• Press „PROG" (2).
• Now you are located in the programming mode for „determining the channels for sequential display".
• Now the LED „PROG" (2) as well as the LED „ALM" (C) light up.
• By pressing the buttons „CH1" to „CH4" (F, G, H, I) once, you can activate/deactivate the desired chan-
nel (activated = channel LED is red, deactivated = channel LED is off).
• To leave the programming mode, press and hold the button PROG (2) for 2 seconds.
Please note that the device exits programming mode automatically if there is no input
for 30 seconds.
34