Conrad Electronic 75 11 57 Bedienungsanleitung Seite 29

11 Button ">"
Reduces the value for contrast, brightness, colour and hue in picture mode.
12 Guide for attaching the base foot
For attaching the base foot, see chapter 8a
13 Loudspeakers
Plays back sound fed in through the "audio in" jack. The volume cannot be adjusted.
14 Connection for power pack (12 V/DC)
15 Connection for adapter cable (19)
16 Headphone connection (3.5 mm mono jack)
17 ALARM connection terminal
Up to 4 alarm loops can be operated on the connections 1-4 and GND.
A recording device with an alarm input can be connected to OUT.
18 Base and mounting support
19 Adapter cable
A Standby LED
Indicates whether the device is completely on (green) or is on standby (red).
B LED „DWELL TIME/ALM SEQ"
This is a status LED; which has different meanings depending on the programming mode. To assign
the corresponding status, please read chapter 10, 11, 12.
C LED „ALM"
Blinks in display mode as soon as an alarm was detected.
This is a status LED, which has different meanings depending on the programming mode. To
assign the corresponding status, please read chapter 10, 11, 12.
D LED „PROG"
This LED is lit as soon as you are in programming mode.
E LED „ALM RESET/SEQ"
Is lit in display mode as long as differential playback is active.
This is a status LED, which has different meanings depending on the programming mode. To
assign the corresponding status, please read chapter 10, 11, 12.
29