Kompernass E-4573 Bedienungsanleitung Seite 20

 Take the natural-stone "stairs" body out of the water tank
and place it beside the water tank.
 Turn the natural-stone "stairs" body backside down. The bot-
tom of the "stairs" body with the fixed water pump and the
water-resistant lamp is upside down and in front of you.
 Rotate the switch on the front side of the waterpump to
adjust the pumping rate:
• Rotate towards "MIN" for lower pumping rate.
• Rotate towards "MAX" for higher pumping rate.
 Replace natural-stone "stairs" body and water pump to their
original position and decorate the stairs with the stones.
 Connect the water pump power cable to the transformer
power cable and plug the transformer in a mains socket. Your
natural-stone water fountain is ready for operation again.
. Maintenance
Dirty water (e.g. from dust) may cause malfunction during ope-
ration; this may cause damages to the water pump!
Replace dirty water by fresh distilled water once a week.
IRL
 | Operating Instructions
To do so ...
 Unplug the transformer.
 Disconnect the water pump power cable from the transfor-
mer power cable.
 Remove the decorative stones from the stairs.
 Take the natural-stone "stairs" body with the fixed water
pump out of the water tank and place it beside the water
tank.
 Remove the black rubber plug from the opening of the rear
wall of the water tank and pull out the power cable.
 Carefully empty the water tank.

Pull the power cable through the opening in the rear wall
of the water tank, replace the rubber plug and push it back
into the opening.
 Fill the water tank with distilled water to the "MAX" mark
inside the tank.

Replace the natural-stone "stairs" body with the fixed water
pump to their original position in the water tank. Decorate
the stairs with the stones.