Installation; Setting Up; Connecting And Commissioning - Tetra AquaArt 20 Gebrauchsanleitung

 Check whether there are any leaks.
 If the aquarium is leaking, empty it and exchange it
at your retailer.
 If it is not leaking, empty it and position it in its
permanent installation location.

Installation

ATTENTION!
Damage to the aquarium and glass breakage
due to improper transport.
 Empty the aquarium each time before it is
transported.
 Use a second person to help lift and
transport the aquarium.
 Lift the aquarium by the lower frame only.
ATTENTION!
Damage to the aquarium due to the selection
of an unsuitable installation location.
 Make sure that the installation location has
the necessary load-bearing capability.
Permanent location must be strong enough
for at least three times the estimated mass
of the filled aquarium. Information on this
can be obtained in the section entitled
Technical Data
 Make sure that the installation location is
flat, level and waterproof.
Earthed 220 V - 240 V ~ 50 Hz sockets for the
electrical accessories must be located in the vicinity
of the installation location.
Further information on the installation location
and tips for setting up an aquarium can be
found in the enclosed Tetra brochure.
 Tilt the aquarium slightly.
 Grip it by the lower frame.
 Transport it to the intended permanent installation
location.
 Place the aquarium down.
from page 16

Setting up

Once the aquarium has been prepared, it can be
decorated according to your wishes. The type of
decoration depends on the specific use. Decoration
suggestions and tips can be found in the enclosed
Tetra-brochure.
Connecting and
commissioning
DANGER
Fatal injury due to electric shock.
 When installing electrical accessories, make
sure that the cables are not damaged.
 Check the cables for cuts or notches.
 Do not operate the aquarium if cables are
damaged.
ATTENTION!
Damage to the cover and flap hinges.
 Proceed carefully when removing the flaps.
The rear flap (Fig. A, 5) must first be removed to
connect accessories with mains plugs.
 To do this, open the flap 45°.
 Gently lift upwards.
 Remove the flap.
 Store the flap in a secure location.
 Make sure that the mains power cables or hoses
for accessories are also guided through the
corresponding cable passages (Fig. A, 7).
The cable passages are blocked on delivery.
 Carefully break out the blocks by hand or with a
suitable pair of pliers.
 Insert the cable into the guide.
 To reinsert the flap, first engage one pivot pin
directly into the corresponding hole in the flap
pivot.
 Then engage the opposite hinge.
 Close the cover.
English operating instructions
13