Cleaning And Maintenance; Emptying The Dust Container - SACH Vac dynamic Bedienungsanleitung

USER GUIDE
Turn off of the central vacuum unit: if you press the
control panel, you will be able to turn it off, decreasing the power with the
pressing the "RESET" button.
If you start up the unit from the hose you would not turn it off using the "RESET" button.

7. CLEANING AND MAINTENANCE

The effectiveness of the central vacuum unit and its optimum performance is dependent on its
correct use and maintenance. It is recommended that cleaning and maintenance is undertaken on
a regular basis to prevent mechanical breakdowns.
The central vacuum unit must be disconnected from the electrical supply.

EMPTYING THE DUST CONTAINER

CLEANING AND MAINTENANCE OF THE FILTER
1
1. Detach the container from the central vacuum unit.
2. Access the protective filter located inside and remove it by turning it 90 º anti-clockwise.
3. This protective filter is re-useable and can be washed using neutral soap and water. Wait until
it is completely dry before refitting it.
4. To access the HEPA filter follow the same procedure as for the protective filter and wash in the same
way. Don't forget to wait until the filter is dry before refitting it.
5. Check that both filters are in perfect condition. Never refit damp or damaged filters. Also, to use the
central vacuum unit without filters would damage it.
6. Refit the HEPA filter and adjust the connecting cover by turning it clockwise until it locks firmly
in place.
7. Refit the protective filter with its support, turning it clockwise until it locks into place.
button in order to start up the unit, from the
2 3
29
button and finally by
1. Detach the container by
unfastening the clamps.
2. Remove the Cyclonic Filter.
3. Empty the dust container.
4. Ensure the Cyclonic Filter is
repositioned correctly.
4
VAC BY SACH
R