SACH Vac dynamic Bedienungsanleitung Seite 29

USER GUIDE
VAC DIGITAL
1. PANEL
2. RESET BUTTON
3. LOW VOLTAGE LINE
4. ELECTRICAL SUPPLY CABLE
5. WALL HANGER
6. DETACHABLE DUST DEPOSIT
HOLDFAST-HANDLE
GENERAL INSTRUCTIONS FOR DIGITAL MODELS
1. Connect the power cable (4). The "power" pilot on the LCD panel of the DIGITAL model will be
permanently lit indicating that it is connected to the power supply. The central vacuum unit is now
ready for use. Your appliance comes to you from the factory already prepared. You do not need to
set it up or make any adjustments.
2. To prepare the hose for use, connect the telescopic wand and the appropriate tool for the type of
floor surface you wish to clean, to the hose handle.
3. Connect the hose to the system by inserting its cuff into an inlet valve. Turn the system on by sliding
the switch on the low-voltage hose handle to the ON position, assuming your central vacuum unit
comes with this option. If not, the system will automatically turn on when the hose is connected to
the inlet valve. For models with a low-voltage hose with a speed control facility, adjust this according
to the type of surface which you wish to vacuum.
POWER
MAX
MIN
RUN
HEPA
DUST SERVICE
POWER
MAX
MIN
RUN
Mode
27
VAC BY SACH
7. MOTOR
8. EXHAUST OUTLET
9. DIRTY AIR INLET
10. PROTECTIVE FILTER
11. HEPA FILTER
12. COVER HEPA FILTER
13. CYCLONIC CONE
14. DUST CONTAINER
digital
HEPA
DUST SERVICE
Reset
R