G) Delete Mode "Clr - VOLTCRAFT 4500ADVANCED Bedienungsanleitung

• By briefly pressing the "
tion g). If you want to correct the overload settings, briefly press the "SET" button (1) and
proceed as described above.
If you want to close the set-up mode, hold the "SET" button (1) pressed for 3 seconds
(or do not press a button for one minute).

g) Delete mode "CLr"

Two function for deleting the saved information/settings can be used:
• "CLr USEr SEt" function
This will delete the following settings:
- Electricity tariff
- CO emission per kWh (kg/kWh)
2
- Value for overload alarm
• "CLr ALL dATA" function
This will delete/reset the following data:
- Energy (kWh)
- Costs
- Operating duration
- Value for CO emission
2
- Maximum value for power and current
Only measurement data are deleted. This is recommended when another load is con-
nected or if you want to restart the measurement process.
Proceed as follows:
• If you have set the limit value for the overload alarm (see section f) before selecting delete
mode, you can proceed directly with the next step.
Otherwise, the set-up mode must be started by pressing the "SET" button (1) for approx.
3 seconds. "
pears in the upper display. Press the "
see next step.
42
" button (5) you can access the delete mode, see next sec-
" will be shown in the top left of the display and "24Hr" (or "12Hr") ap-
" button (5) briefly 4x to open the delete mode,