Maintenance And Cleaning; Technical Data; Troubleshooting - Renkforce 1232670 Bedienungsanleitung

• Feed the discharge hose directly into a water drain. Check that the hose is at a
gradient for its entire length and that it is not bent, knotted or blocked so that the
water can discharge safely and without obstruction. Regularly check that the
discharge hose is in a secure position and that it has a tight seal.
• As the dehumidifier does not feature a pump, the water can only drain downwards.
• Slide the water tank back into the device.

Maintenance and cleaning

a) General
• The product does not require maintenance except for occasional cleaning. Turn the
product off before cleaning or maintenance work and remove the mains plug from
the socket.
• Remove the water tank (8) as described under "d) Emptying the water tank". Rinse
the tank thoroughly with lukewarm water. Clean the water tank exterior with a soft,
damp cloth.
• Clean the exterior of the dehumidifier with a soft, damp cloth and then wipe with a
dry cloth.
• Do not use any abrasive or chemical cleaning materials, as these could damage the
plastic parts of the product.
• Ensure that no water gets into the interior of the device.
b) Cleaning the filter
• Never operate the appliance without a filter!
• Clean the filter with the utmost care to avoid damaging it.
• Depending on the operating conditions, the filter should be cleaned every 4 weeks.
• Do not use any abrasive or chemical cleaning materials as these could destroy the
filter.
• Remove the water tank (8). The filter is located directly above the tank, behind the
air inlets (6). Pull the filter downwards and remove it from the appliance.
• Clean the filter with a soft brush or the brush attachment of your vacuum cleaner.
If the filter is very dirty you can clean it carefully in lukewarm water (the water
temperature must be under 40 °C). Let the filter dry completely.
• Put the dry filter back into the dehumidifier. Be careful not to bend the filter.
Storage
• If you are not going to use the dehumidifier for an extended period of time (more
than one week), let it dry completely along with all components.
• The dehumidifier must not be stored with a dirty filter or when there is water in the
water tank.
• Keep the dehumidifier upright in a cool, dry location away from direct sunlight and
dust.

Troubleshooting

Problem Possible cause
The machine is not The mains socket is not
working. connected.
The TANK FULL LED is on.
The water tank (8) is not
inserted properly.
The room temperature is
over 32 °C or under 5 °C.
The humidity in the room
is already very low.
The appliance Is the room too big for the
produces little or no rating of the machine?
condensation.
The air inlets or outlets
(1 +6) are blocked or
covered.
The filter is dirty.
The dehumidifier is very The dehumidifier is
loud during operation. not installed correctly,
positioned on a slope or is
unstable.
Suggested solution
Connect the mains socket to
the mains.
Empty the tank.
Check that the tank is in the
correct position.
The safety thermostat
disables operation at tem-
peratures above or below
these limits. Wait until the
temperature changes to a
level at which operation is
permitted.
Compare the size of the
room with the values given
in the "Technical data".
Make sure that the air inlets
and outlets (1+6) are not
covered.
Clean the filter.
Place the dehumidifier on a
horizontal, stable and even
surface.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.

Technical Data

Operating voltage................................220 - 240 V/AC, 50 Hz
Power consumption............................max. 250 W
Dehumidifying output ......................... 1 0 l/24 hours (at a room temperature of 30 °C /
Room size .............................................max. 15 m
Noise level............................................43 - 45 dB(A)
Volume of water tank .........................2.2 l
Coolant/quantity ..................................R134a / 80 g
Air flow rate .........................................max. 110 m
Protection class ..................................I
Operating conditions ..........................+5 to +35 °C, <90 % RH
Storage conditions..............................+8 to +45 °C, <90 % RH
Cable length .........................................180 cm
Dimensions (W x H x D)......................362 x 508 x 220 mm
Weight . ..................................................11.5 kg
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2014 by Conrad Electronic SE.
80 % relative humidity)
2
/h
3
V1_1114_02-DS