Intended Use; Delivery Content; Safety Instructions - Renkforce 1232670 Bedienungsanleitung

Operating instructions
Dehumidifier 10 l
Item no. 1232670

Intended use

This appliance can be used to avoid damp walls and the formation of mould in rooms
with a high humidity such as living rooms, storage rooms and cellars. The dehumidifier
has a maximum dehumidification capacity of 10 litres per day, depending on the
temperature and humidity of the room. Excess moisture is collected in the water tank
as condensate and the dehumidified air is blown back into the room at a slightly higher
temperature. The extracted water can be discharged via the water tank or drained
regularly/continually using a discharge hose. A suitable discharge hose is available
separately.
The product is not intended for commercial, mechanical or industrial use. No warranty
will be provided if the appliance is used in a commercial, mechanical or industrial
setting.
For safety and approval purposes (CE), you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All
company names and product names are trademarks of their respective owners. All
rights reserved.

Delivery content

• Dehumidifier
• Operating instructions

Safety instructions

Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may
become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong
jolts, high humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a
low height can damage the product.
• This device is not intended to be used by persons (including children) with
reduced physical, sensory or mental abilities or lack of experience and /
or lack of knowledge unless they are supervised by a person responsible
for their safety or have received instructions on how to use the device.
• Children should be supervised to ensure that they do not play with the
device.
• Before connecting to the mains, make sure that your local AC mains
voltage matches the specifications on the nameplate.
• Never pour any liquids over electrical devices or put objects filled with
liquid right next to the device. If liquid or an object enters the interior of the
device nevertheless, first power down the respective socket (e.g. switch
off circuit breaker) and then pull the mains plug from the mains socket.
Do not operate the product anymore afterwards, but take it to a specialist
workshop.
• Never use the product immediately after it has been brought from a cold
room into a warm one. The condensation generated could destroy the
product.
Allow the product to reach room temperature before connecting it to the
power supply and putting it to use. This may take several hours.
• The mains outlet must be located near to the device and be easily
accessible.
• Always lay the cables so that nobody can trip over or become entangled
in them. This poses a risk of injury.
• When setting up the product, make sure that the cable is not pinched,
kinked or damaged by sharp edges.
• Never pull the mains plug from the socket by pulling at the cable. Always
pull it from the mains socket using the intended grips.
• Unplug the mains plug from the mains socket if you do not use the device
for an extended period of time.
• Disconnect the mains plug from the mains socket in thunderstorms for
reasons of safety.
• Avoid excessive thermal stress on the mains cable from extreme heat or
cold. Do not modify the mains cable. Otherwise the mains cable may be
damaged. A damaged mains cable can cause a deadly electric shock.
• Do not touch the mains cable if it is damaged. First, power down the
respective mains socket (e.g. via the respective circuit breaker) and then
carefully pull the mains plug from the mains socket. Never use the product
if the mains cable is damaged.
• A damaged mains cable may only be replaced by the manufacturer, a
workshop commissioned by the manufacturer or a similarly qualified
person, so as to prevent any danger.
• Never plug in or unplug the mains plug when your hands are wet.
• Do not leave the appliance unattended while in operation.
• The appliance must only be used in enclosed indoor areas.
• Do not operate the appliance near flammable gases or substances, open
flames or in a location where oil or water may spray onto the device. Do
not use the product near to a bath, shower or swimming pool.
• Never pour or spray water over the product as there is a risk of a fatal
electric shock!
• Do not place any objects on the appliance.
• Do not cover the air inlets and outlets on the appliance. The appliance
must not be placed behind curtains or other objects that may interfere
with the circulation of air. The appliance should be placed at a distance of
at least 50 cm from other objects for safety reasons.
• Do not insert any objects or fingers into the interior of the appliance.
• Do not direct the air outlet at people or animals.
• Always transport the product in an upright position using the handles
intended for this purpose. Empty the water tank before moving the
appliance. Place the appliance upright immediately after transport and
wait for at least 1 hour before turning it back on.
• The appliance must always be kept straight and upright so that the
compressor is not damaged and the refrigerant can flow properly.
• Consult an expert when in doubt about operation, safety or connection of
the device.
• Maintenance, modifications and repairs are to be performed exclusively
by an expert or at a qualified shop.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.