Handling The O-Ring; Set The O-Ring In Place - Sony Marine Pack MPK-DVF7 Bedienungsanleitung

Handling the O-ring

Set the O-ring in place

Avoid setting the O-ring in dusty or sandy locations.
1
Remove the O-ring.
Do not use pointed or metal objects to remove the O-ring. These objects might scratch or
damage the marine pack groove or O-ring.
2
Inspect the O-ring.
•Fully check the following, and wipe off with a soft cloth or tissue paper.
– Check for any dirt, grains of sand, hair, dust, salt, thread scraps, etc.
– Check for any old grease.
v Dirt
• Lightly run your fingertip around the O-ring to check for any unapparent dirt.
• After wiping the O-ring, take care to prevent any cloth or tissue paper fibres from
remaining on the O-ring.
• Check the O-ring for cracking, skew, distortion, fine splitting, scratches,
sand-biting, etc. Replace cracked or scratched O-rings.
v Cracking
3
Inspect the O-ring groove.
Grains of sand or hardened salt sometimes get into the groove. Carefully remove them by
blowing with an air spray or by wiping them with a cotton wool bud. Prevent fibre scraps from
the cotton wool bud from entering inside.
4
Also, inspect the contacting surface on the other side of the O-ring in the same way.
v Sand v Hair
v Skew v Distortion
v Dust v Salt
v Fine Splitting v Scratches
GB
v Thread scraps
v Sand-biting
continued
23
-GB