Troubleshooting - Sundaya Ulitium Lightkit Betriebsanleitung

Troubleshooting

If for some reason, you
tried switching on a Ulitium
and it does not want to
light up, please follow these
troubleshooting steps:
1. Push the Master Switch, and
then try switching on again.
2. If during daylight the green
indicator is blinking, give
the lamp some time to store
enough energy before using
the lamp again in the evening.
3. Try unplugging the Bayonet
Plug on the Ulitium and
plugging it back in, before
attempting to switch on the
lamp again. This will reset the
Ulitium's protection circuits.
4. Check the cabling from
the LEC all the way to this
Ulitium, and verify all plugs
are connected, to make sure
the Ulitium has been getting
energy from the LEC during
the day. If a cable is broken
or damaged at some point,
replace.
15