VOLTCRAFT ES-5 Bedienungsanleitung Seite 20

• Strip approx. 6mm from the cables. Slide the corresponding cable connection over a
conductor and guide each conductor in the corresponding hole.
Afterwards, guide the conductor in the corresponding terminal clamp and screw it on firmly.
Tighten the cable connection firmly in order to guarantee a secure strain relief.
• Install the cable for the power supply of the "ES-5" (mains voltage 230V~/50Hz).
Use appropriate installation cables only. Should flexible conductors be used, you must use
appropriate cable end-sleeves.
• Connect the inverter module with the "ES-5".
• Connect the solar installation with the "ES-5".
• Connect the cable for the power supply of the "ES-5" to the mains voltage connection.
Caution!
The power supply must not be switched on.
• Close the housing (4 screws).
• Once more check the correct connection of all cables.
• Switch on the power supply of the "ES-5" once all installation work is completed.
• Aftera brief self-test, the current and voltage indication appears in the display.
20