VAPANION REVENGER MINI Bedienungsanleitung Seite 87

USING THE DEVICE
Please note the following:
Before first using, drip a few drops of your e-liquid onto the atomizer head (head) and leave it
in the e-liquid-filled tank for about 15 minutes after installation before you vape. Do not clean
the atomizer head with water. If necessary, simply wipe with a dry cloth Because atomizer
heads are wearing parts, they must be changed regularly.
Adjusting the Air Supply
There is a airflow control ring located on the head base of the device. It can be adjusted
by slightly turning and is adaptable to your vapor preferences. The more air flows through
the device (the more the slots are open), the lower is the drawing resistance. Pay particular
attention to a sufficient air supply during sub-ohm vaping.
Changing the Mouthpiece
The mouthpiece is placed on the top cap of the clearomizer. It can be removed by gently
pulling up and once again attached by applying gentle pressure on clearomizer.
The mouthpiece may be cleaned with warm water. Make sure that it is completely dry
before reinserting into the clearomizer.
VAPANION
REVENGER MINI
85