Overview Of Controls - Siemens SIDOOR Betriebsanleitung

Parameter documentation
Note
After the optimal settings of the parameters have been determined, they should be noted in the configuration record (see
Appendix Setting record (Page 37)). These records should also be kept at hand when asking questions on the Hotline.
3

Overview of controls

Control elements
X7 X5
VCC
ACCUMULATOR
MODE
CH A
CH B INPUT ENCODER AND
MOTOR IDENTIFICATION
M-ID
GND
PE
M2 OUTPUT MOTOR SUPPLY
M1
X3
+
INPUT POWER
PE
SUPPLY
-
X1: Flat cable connector for the add-on modules
X3: Power supply connection
X4: Voltage output 24V / 0.4A
X5: Input signal emergency power module
X6: Connector for input signals
● Input 1 (adjustable function)
● Input 2 (Nudge)
● Input 3 (Close)
● Input 4 (Open)
X7: Motor plug
X8: Connector for Service Tool and USB adapter
H401: 7-segment display for door status and event codes
S401: Learn run
S402: Service button OPEN
S403: Service button CLOSE
X14: Flat cable connector for relay module
(optional) or CAN module (optional)
X15: Flat cable connector for the terminal module
H1: LCD display
S1-S4: Operator buttons for terminal module
Figure 3-1 Overview of controls
ATD400V hoisting and rolling shutter drive for elevators
A2B00101050-01, 07/2012
COMFORT DOOR CONTROLLER
Siemens AG, Am Brabrinke 14, D-30519 Hannover
RELAY MODULE OR CAN MODULE (OPTIONAL)
X14
19x38mm
Made in Germany
MODULE CONNECTION TERMINAL MODULE
X1 X15
H1
S1 S2
ESC
S401 S402 S403
H401 LEARN RUN OPEN CLOSE
X4
DC-OUTPUT
-
24V
+
400mA
X6
-
INPUT 1
+
S3 S4
-
RETURN
+
INPUT 2
+
INPUT 3
+
INPUT 4
X8
SERVICE
TOOL
DC-INPUTS
MIN. 10V
MAX. 28V / 27mA
25