Safety Information - Siemens SIDOOR Betriebsanleitung

1

Safety information

Before commissioning, please note:
Please read through these instructions carefully. They contain essential information for the installation, use and safety of the
equipment.
Qualified personnel and equipment handling
WARNING
Risk of injury due to dangerous electrical voltages and moving mechanical parts.
Only appropriately qualified personnel may work on or in the vicinity of the equipment. Personnel must be thoroughly
familiar with all the warnings, notices, and functions of the ATD400V door controller described in the operating instructions.
In the context of the operating instructions and warning notices, a qualified person is a person who is familiar with
assembling, installing, commissioning, and operating the product, and who has the relevant qualifications, such as:
● Training, instruction or authorization to switch on and off electric circuits and devices / systems in compliance with
safety engineering standards.
● Training or instructions in the maintenance and use of appropriate safety equipment in compliance with safety
engineering standards.
● First aid training.
The successful and safe operation of the equipment is dependent on proper transportation, storage, installation, and
assembly, as well as on careful operation and maintenance. Before commissioning, all electrical connections must be
inspected to ensure that all contacts are secure.
WARNING
Risk of injury due to dangerous electrical voltages and moving mechanical parts.
Disconnect the door drive by unplugging the power plug from the power supply before you start work on the door drive.
WARNING
Risk of injury and damage to property due to excessive closing force of the door.
Violation of the static closing force may lead to personal injuries, damage to the door drive and to mechanical components
of the door.
Taking the counterweights into account, the maximum static closing force must not exceed 150N!
Changes to the door drive are not permissible.
CAUTION
Loss of liability for defects and damage to property
Changes to the door drive lead to the loss of liability for defects and compensation rights ,and the correct function of the
door drive is no longer guaranteed.
Note the following rules:
● Do not make any changes on the door drive (motor, controller, power supply).
● Do not carry out a permanent connection as this does not ensure a proper and required necessary disconection from
the mains.
● Do not remove the protective Schuko-type socket under any circumstances (e.g. by truncating).
● Disconnect the system from the power supply before you begin working on the door drive.
ATD400V hoisting and rolling shutter drive for elevators
A2B00101050-01, 07/2012
23