wehncke Manhattan Bedienungsanleitung Seite 17

ART.NO. Horizontal beam 124 cm
12305
12306
12307
A connected frame is attached to both long sides to increase pool stability. While pool 12305 is equipped
with two "u-shaped" side supports on each side, pool 12306 and 12307 have three and five "u-shaped"
side supports on each side respectively.
6. Connect the horizontal beams. Start with the 124 cm beam and connect it to half of the available 130
cm beams. Now connect the other 124 cm beam to the rest of the longer beams for the other side of
the pool.
7. Slide a connected beam into the sleeve opening underneath the inflatable ring on both sides of the
pool.
8. Slide the "u­shaped" side supports through the liner straps attached underneath the pool at the
sides.
9. Attach the connectors to the ends of the "u­shaped" side supports.
10. Connect the "u­shaped" side supports to the horizontal beams by inserting the pin of the connectors
into the holes in the horizontal beams.
1 1. Inflate the upper ring. For this task, use a double action pump or an electric air pump from the
Wehncke pump range for this task. Only inflate the ring to 85% pressure and ensure it is within the area
of the pool floor. Do not over inflate the ring: Otherwise the liner or the seams could be damaged.
12. Enter the pool in your bare feet and carefully smooth out the liner.
022-09_FRI_12305_Manhattan_GBR_Korrektur.indd 17
Horizontal beam 130 cm
X2
X2
X2
"U-shaped"
side supports
X2 X4
X4 X6
X8 X10
Beams and side supports for one side of pool 12305
Connector
X8
X12
X20
17
08.03.2010 14:24:24 Uhr