Cleaning And Maintenance - Ideen Welt P8-RM-SI Bedienungsanleitung

Note:
Exert as little pressure as possible on the hot branding extensions ⑦. They are made out of brass
and could become deformed. The branding effect should mainly be created by the heat.
Larger branding extensions ⑦ may cool down a little during the branding process. In this case,
wait a few minutes until the branding extension ⑦ has heated up again fully.
Soldering
1. Screw the desired soldering tip ⑥ onto the branding rod ① as described above.
2. Place the branding rod ① onto the stand ② so that the Y-shaped mount on the stand ②
supports the branding and soldering iron between the sleeve and the handle ③ (see fold-out
page).
3. Connect the mains plug ④ to a suitable and easily accessible mains socket. Ensure that the
power supply is suitable. The device is now heating up.
4. Wait for approx. 10 minutes until the soldering tip ⑥ has heated up fully.
5. Hold the device on the handle ③ like a pen while working.
6. Hold the soldering tin ⑤ against the hot tip until the metal liquefies and flows onto the point to
be soldered. Melt the soldering tin (with soldering flux) between the soldering point and the
soldering tip ⑥. Add further soldering tin until the entire soldering point has been wetted.
7. Allow the solder to solidify and avoid any vibrations.
8. Clean the soldering tip ⑥ with a clean, damp sponge.
After cleaning, the soldering tip ⑥ must be tinned:
Tin the hot soldering tip ⑥ by melting the soldering tin ⑤.
9. Disconnect the mains plug ④ from the mains socket after finishing your work and allow the
device to cool down for at least 30 minutes.
Note:
The soldering and branding iron has a nominal power rating of 30 Watts and is thus ideal for
soldering electronics. It is particularly suitable for hard to reach areas and fine soldering work due
to its design. The best results are achieved with electric solder with a diameter of 1.0 or 1.5 mm,
60% Sn, 40% Pb. We recommend using a contact paste as a soldering flux (not soldering flux
grease or soldering flux liquid). The soldering flux is either contained in the solder or is applied
separately.

CLEANING AND MAINTENANCE

ATTENTION! RISK OF INJURY! Always disconnect the
mains plug from the mains socket and allow the appliance
to cool down before carrying out any work on the
appliance.
1. Make sure you have read the safety instructions before cleaning.
2. Clean the device after finishing your work.
3. Use a cloth and, if necessary, a mild cleaning agent for cleaning the device.
4. Make sure that no water penetrates into the openings. Always rub the device dry after cleaning
it. All components must be dry before they are used again.
5. Do not use sharp objects, benzene, solvents or cleaning agents that damage plastics under any
circumstances.
6. Keep the appliance and all its accessories in a location that is protected from dust, moisture and
direct sunlight.
G