Ideen Welt P8-RM-SI Bedienungsanleitung Seite 22

of the mains socket. Do not wind the cable around the appliance.
Keep the mains cable away from heat, oil and sharp edges.
Ensure that the mains cable is not crushed, bent or scoured.
34. Arrange the mains cable so that it is not possible for anyone
to unintentionally pull or trip over the mains cable.
35. If using an extension cable, it must be suitable for the
corresponding power requirements.
36. This appliance should not be operated with an external timer
or a special remote control system.
37. RISK OF INJURY! Disconnect the mains plug prior to every
cleaning, break in work, when the device is left unattended or in
the event of malfunctions or hazardous situations.
38. Never leave the device unattended when it is in use.
39. RISK OF BURNING! Never touch the heated branding rod
the branding extensions, molten solder or heated work pieces.
Only touch the device on the handle! It is essential to allow the
device to cool down before changing, cleaning or checking the
device components.
40. Do not allow hot soldering tin to come into contact with people
or animals. In the event of contact with the skin, hold the affected
area under cold running water for a few minutes.
41. RISK OF FIRE! Always place the hot device on the supplied
stand. Risk of fire!
42. RISK OF BURNING! The stand can become hot when the
branding and soldering iron is stored on it.
43. The surrounding conditions should be adapted to fit the
device and the task. Do not use this device for heavy duty work.
44. A work piece secured in place with a clamping device or vice
is more secure than one held with your hand.
45. Also observe the safety instructions issued by the
manufacturer of the soldering tin when soldering.
46. Do not dispose of soldering waste with your household waste.
Soldering waste is classified as hazardous waste.
G