VOLTCRAFT PB-6 Bedienungsanleitung Seite 3

OPERATING INSTRUCTIONS
PB-6 POWER BANK, 3000mAh
ITEM NO.: 1226994
INTENDED USE
Use the product to charge a mobile device (e.g. smartphone) in a protected indoor area. Use
a suitable USB power supply to charge the internal battery.
The product features a battery level indicator and is protected against overload. Suitable
adapters are needed to connect mobile devices.
The product also features an LED light, allowing it to be used as a torch.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If
you use the product for purposes other than those described above, the product may be
damaged. In addition, improper use can cause hazards such as short circuiting, fire, electric
shock etc. Read the instructions carefully and keep them. Make this product available to third
parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
DELIVERY CONTENT
• Power bank
• Micro USB charging cable
• iPhone adapter
• Nokia adapter
• Mini USB adapter
• Storage pouch
• Operating instructions
SAFETY INSTRUCTIONS
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product. Allow the
product to reach room temperature before connecting it to the power supply and
putting it to use. This may take several hours.
• Never leave the product unattended during use.
• The charger housing warms up during operation. Ensure that there is sufficient
ventilation. The charger housing must not be covered!
VERSION 10/14 • Make sure that the cable is not pinched, kinked or damaged by sharp edges.
• Do not look directly into the LED light! Do not look into the beam directly or with
optical instruments!
b) Rechargeable batteries
• The rechargeable battery is permanently built into the product and cannot be
replaced.
• Never damage the rechargeable battery. Damaging the casing of the
rechargeable battery might cause an explosion or a fire! Unlike conventional
batteries/rechargeable batteries (e.g. AA or AAA type), the casing of the LiPo
rechargeable battery does not consist of a thin sheet but rather a sensitive plastic
film only.
• Never short-circuit the contacts of the rechargeable battery. Do not throw the
rechargeable battery or the product into fire. There is a danger of fire and
explosion!
• Charge the rechargeable battery regularly, even if you do are not using the
product. Due to the rechargeable battery technology being used, you do not need
to discharge the rechargeable battery first.
• Never charge the rechargeable battery of the product unattended.
• When charging, place the product on a surface that is not heat-sensitive. It is
normal that a certain amount of heat is generated during charging.
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
If you are not sure about the correct connection or use, or if questions arise which are not
covered by these operating instructions, please do not hesitate to contact our technical
support or another qualified specialist.
OPERATING ELEMENTS
1 Battery level indicator
2 On button
3 LED light
4 IN 5V charging port
5 OUT 5V user connection port
1
2
3
4
5
6
7
8
9
6 Micro USB charging cable
7 USB-A connector
8 Micro USB connector
9 Adapters (Nokia and mini USB not
shown)