Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Game camera HD, 12 MP
Item no. 1218294
Intended use
This game camera takes pictures and videos and is equipped with one middle and two side PIR sensors. The
PIR sensor (passive infra-red) recognizes a sudden change in the ambient temperature, which is triggered
by game. The camera is ideal for observing wildlife as it can be fastened temporarily to various objects. The
product can be flexibly fastened to trees, pipes or similar round objects using the included fastening strap.
Single photos, videos and time lapse recordings can be taken with the camera. The pictures and videos are
stored on a SD card (not included in the scope of delivery). The pictures or videos taken can then be copied
onto a computer and viewed on a monitor.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the
product for purposes other than those described above, the product may be damaged. In addition, improper
use can cause hazards such as short circuiting, fire, electric shock etc. Read the instructions carefully and
keep them. Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Game camera
• Video cable
• USB cable
• Fastening strap
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become dangerous
playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from
any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage
the product.
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
• The camera is weatherproof and is suitable for outdoor use. Nevertheless, make sure that the
camera is not submerged in water or other liquids as failure to do so causes damage to the
camera. Do not expose the operating device to damp or wet.
• Do not expose the game camera for long periods to direct sunshine. It can be damaged by
overheating. Install the game camera so it lies in the shade.
• Never touch the contacts (14, 16) of the camera and battery box with a metal object. This can
trigger a short circuit and damage the camera.
• Do not use the camera for direct surveillance of persons.
b) Batteries
• Correct polarity must be observed while inserting the batteries.
• Batteries should be removed from the device if it is not used for a long period of time to avoid
damage through leaking. Leaking or damaged batteries might cause acid burns when in
contact with skin, therefore use suitable protective gloves to handle corrupted batteries.
• Batteries must be kept out of reach of children. Do not leave batteries lying around, as there is
risk, that children or pets swallow them.
• All batteries should be replaced at the same time. Mixing old and new batteries in the device
can lead to battery leakage and device damage.
• Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-
rechargeable batteries. There is a risk of explosion!
c) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• Maintenance, modifications and repairs are to be performed exclusively by an expert or at a
qualified shop.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
Operating elements
1
Version 02/15
2
3
4
5
6
7
8
9
Rear with display and buttons
16
17
18
19
20
21
22
1 IR LED field
2 Camera lens
3 PIR sensor
4 Side PIR sensors (motion detectors)
5 Rubber cover for power supply connection
6 Tripod thread
7 Bottom cover
8 Fastening strap
9 Video cable
10 USB cable
11 Fixing screw
12 Clamp
13 Battery compartment cover
14 Contact pins
15 Battery box
16 Contacts
Battery and mains operation
a) Battery operation
1. 4 pieces 1.5 V/DC type AA/LR6 batteries are necessary for operation. If possible use high quality alkaline
batteries.
2. Open the bottom cover (7). Turn the safety lever (22) to open the bottom cover.
3. Press the arrow on the battery compartment cover to open it.
4. Heed correct polarity. 2 batteries each must be inserted into one compartment with the same polarity.
The polarity is indicated on the battery compartment cover with + and –. The corresponding battery pole
must point upwards in the direction of the battery compartment cover.
5. Close the battery compartment cover.
b) Battery box
Connect the battery box to the back of the game camera. The fastening strap for installation is fastened onto
the battery box. If you need an additional energy source you can insert 4 additional 1.5 V/DC batteries of type
AA/LR6. As soon as the batteries in the game camera are nearly used up, the device automatically switches
to the battery box which enables a longer battery running time.
1. Lift up the battery compartment cover (13) and insert 4 pieces 1.5 V/DC batteries of the AA/LR6 type at
the correct polarity.
2. Close the battery compartment cover.
3. Attach the battery box precisely onto the rear of the game camera. Close the two clamps (12) on the side,
so that the battery box is securely fitted to the game camera.
4. Secure the battery box with the fixing screw (11) using a slotted screw driver.
c) Mains operation mode
1. You can also operate the product with a 6 V/DC power supply (not included in the delivery scope) using a
suitable circular connector (external Ø 4.0 mm, internal Ø 1.7 mm) or with equal power supply (e.g. solar
operation). Observe the correct connection values. See technical data.
Bottom with battery compartment
26
25
27
24
28
23
29
30
31
17 LC display
18 ▲ /
(navigation and video) button
19 MENU button
20 ◄ (navigation) button
21 Fixing thread for battery box
22 Safety lever and eye
23 ▼ /
(navigation and camera) button
24 OK / REPLAY button
25 ► / SHOT (navigation and snapshot)
26 Battery compartment cover
27 6V power supply connection
28 TV out connection
29 SD card slot
30 Mini USB connection
31 OFF / ON / TEST switch
15
14
13
12
11
10
Werbung
Inhaltsverzeichnis
