Special Functions - Watts 10021160 Bedienungsanleitung

5.12/ Prio Tank: (Available only with system with two tank (2 and 3)
- On this menu you must choose the primary tank, 1 or 2. The primary tank
will be loaded in priority. The second tank will be loaded when the primary
tank will reach the "Maxtemp tank1" value adjusted on "setting" menu or
when the collector temperature is under the primary tank temperature. In this
case the tank2 will be loaded up the "Maxtemp tank2".
GB
5.13/ °C / °F:

6/ Special Functions:

6.1/ Pump exercise function:
To avoid the jamming of pumps, if they were not activated during the last 48
hours, they will be activated during 15 seconds.
6.2/ Dimmer function:
To avoid current consumption, if no keys has been pressed during 10 minutes
the backlight is dimmed.
6.3/ Security function:
To avoid changes after installation, all installation parameters (system and
Extra function) are not accessible any more after 3 minutes after plugging.
If you want to modify these parameters, you must unplug and re plugs the
controller.
7/ Others:
Corresponding value for sensor PT1000:
(To be check with an Ohmmeter, only when the sensor is disconnected)
-10°C / -14°F
0°C / 32°F
10°C / 50°F
20°C / 68°F
30°C / 86°F
40°C / 104°F
50°C / 122°F
---------------
Service---
Factory setting
Reset op time
Time graf temp
Time graf op
Calib sensors
°C / °F
Prio tank
---------------
Service---
Flow (l/min)
Factory setting
Reset op time
Time graf temp
Time graf op
Calib sensors
°C / °F
960 ohms
1000 ohms
1039 ohms
1077 ohms
1116 ohms
1155 ohms
1194 ohms
- ------
- ------
60°C / 140°F
70°C / 158°F
80°C / 176°F
90°C / 194°F
100°C / 212°F 1385 ohms
120°C / 248°F 1461 ohms
140°C / 284°F 1535 ohms
20
no
no
5m
1h
°C
1--
10
no
no
5m
1h
°C--
1232 ohms
1271 ohms
1309 ohms
1347 ohms