Battery Replacement - BALDER V913 DS ADC Bedienungsanleitung

BATTERY REPLACEMENT

When the led diode located on the inner part of external controls housing starts to blink,
it is a warning for the batteries to be replaced.
1. Open the battery cover (1.).
2.
Push the two pins into the direction of the batteries, so the batteries will be pushed out (2.).
3. Remove the batteries and replace them with the new ones (CR-2032). Push the new batteries
back to their position into the battery holders (3.a) and close the battery cover (3.b.).
1.
3.a
2.
3.b
11