Cleaning And Care; Technical Data - RTC ASE 5 Bedienungsanleitung

• Important advice: Do not use the machine non-stop for more than 10 minutes. Allow the machine to
cool down for about 30 minutes before using again.
Changing the knife
• Two cutting knives are included with the machine. The serrated cutting knife can be used for bread, for
example, and the smooth knife for cold cuts, etc.
• Before changing knives, disconnect the power plug.
• Danger of injury! When changing cutting knives, use special caution, and never touch the edges
of the blades! Make sure that the removed cutting knife cannot roll off the table, etc. by itself! Keep
children away!
• With a large screwdriver, turn the fastening screw (3) in the direction of the OPEN arrows until it can be
taken out.
• Carefully take out the cutting knife and insert the new knife.
• Screw in the fastening screw (3) by hand in the opposite direction of the OPEN arrows. Tighten the
fastening screw with a screwdriver.
• Put the removed cutting knife in its original packaging, for example, and store it in a place out of the
reach of children.

CLEANING AND CARE

• Also pay close attention to the Safety Advice.
• Disconnect the machine from power.
• Clean the machine with a slightly moist cloth after use. Then wipe it dry.
• Clean the machine with a soft, moist cloth and mild detergent.
• Never use corrosive or harsh detergents / utensils.
• For easy cleaning, the cutting knife can be removed as follows: Loosen the screw (3) with a crossslit
screwdriver. Carefully take out the cutting knife () with a glove. Do not soak the cutting knife (); this
will remove the lubricant. Only wipe the outer edges with a cloth. After cleaning the cutting knife, fasten
it once again to the machine using the screw (3).

TECHNICAL DATA

Input Voltage :
Output Power :
Instructions on environment protection
Do not dispose of this product in the usual household garbage at the end of its life cycle; hand it over at
a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the
instructions for use or the packing will inform about the methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or other forms of
re-utilization of old appliances, you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorized disposal location.
Printing errors excepted.
Your service hotline for Austria: +43 36 660 606 66
AC 0-30V ~ 50Hz
100-150 W
- 8 -