Safety Instructions - Conrad 62 20 37 Bedienungsanleitung

O P E R A T I N G I N S T R U C T I O N S
Wireless Doorbell
Item-No. 62 20 37
Intended Use
This twin pack doorbell set consists of a wireless bell push and wireless chime. The wireless
chime has 16 different sounds, which can be selected. The signal is transmitted at 433.92 MHz.
The wireless chime is only intended for use in dry indoor locations. However, the wireless bell
push supplied is suitable for outdoor use (IP44).
The wireless chime is powered by 3 x 4.5V/DC Mignon batteries (type: AA) or by a power sup-
ply unit (not contained in the delivery). The bell push is powered by a 12 V battery (type: 23A).
All the safety and operating instructions in this manual must be followed carefully. These instruc-
tions not only protect the device but, in particular, your health. Please read the entire operating
manual before using the product.
This product complies with the applicable National and European requirements. All names of
companies and products are the trademarks of the respective owner.
All rights reserved.
Package Contents
• 1 x wireless bell push
• 1 x wireless chime
• 12V/DC special battery for the wireless bell push
• Double-sided adhesive tape
• Operating instructions
Symbols
A lightning-bolt symbol in a triangle indicates a health hazard, e.g. danger of elec-
tric shock.
The exclamation mark in a triangle indicates a particular risk during handling, oper-
ation and control.
The „Hand" symbol indicates special tips and operating information.

Safety Instructions

The warranty will be void in the event of damage caused by failure to obser-
ve these safety instructions! We do not assume any liability for any
consequential damage!
We do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions. The warranty
will be void in such cases.
• The unauthorized opening, conversion and/or modification of this product
is not permitted because of safety and approval reasons (CE).
• Do not use this product in hospitals or medical institutions. It might cause
interference with the function of life-support equipment. The same may be
the case in other areas.
• The wireless chime is powered by 3 x 4.5V/DC mignon batteries (type: AA)
or by a power supply unit (not contained in the delivery). The bell push is
powered by a 12 V battery (type: 23A).
• The product is not a toy and should be kept out of the reach of children.
• However, the supplied wireless bell push is suitable for outdoor use (IP44).
The wireless chime is only intended for use in dry indoor locations.
• Do not leave packing materials unattended. They may become dangerous
playthings for children.
• Handle the product with care, it can be damaged by impacts, blows, or acci-
dental drops, even from a low height.
• The product should not be exposed to extreme temperatures, direct sun-
light, intense vibration or heavy mechanical stresses.
• This product uses and generates high frequency energy. If the device is not
installed and operated in accordance with these instructions, it can cause
radio interference. If this product causes interference to other equipment,
try one or more of the following measures listed below, in order to restore
normal operation:
- Change the position of the wireless chime.
- Increase the distance between the device affected and the wireless chime
or wireless bell push.
www.conrad.com
Version 06/09
°
Battery notes
• Keep batteries out of the reach of children.
• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the battery.
• Do not leave batteries lying around in the open; there is a risk of them being swallowed by chil-
dren or domestic animals. If swallowed, consult a doctor immediately.
• Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use suitable
protective gloves.
• Make sure that the battery is neither short-circuited nor thrown into a fire. There is a risk of
explosion!
• Do not recharge normal batteries. There is a risk of explosion! Only charge rechargeable bat-
teries which are intended for this purpose; use a suitable battery charger.
• If the door bell is not to be used for a longer period (e.g. storage), remove the battery. Old bat-
teries may leak and cause damage to the product, which will lead to the loss of the warran-
ty/guarantee.
• For the environmentally friendly disposal of batteries and rechargeable batteries, please read
the chapter „Disposal".
Controls
1) Connection for the power supply unit
2) Loudspeaker
3) Status LED
4) Dip-fix switch for selecting the
5) Battery compartment
• After rapid changes in temperature, the product requires approx. 15 min-
utes to stabilise, in order to adjust to the surrounding temperature, before
it can be used.
Wait until the product has reached room temperature, before use.
• Electronic devices are not toys and should be kept out of the reach of chil-
dren!
• Please contact a qualified person, if you are unsure about the safety and
correct use of the system components.
• It can be assumed that safe operation is no longer possible if:
- the device is visibly damaged,
- the device does not function any longer and
- if the device was stored under unfavourable conditions for a long period
of time
or if the device has been subjected to unsuitable conditions during trans-
port
• In commercial institutions, the accident prevention regulations of the
Employerís Liability Insurance Association for Electrical Systems and
Operating Materials are to be observed.
• Maintenance, adjustment and repair may only be carried out by a qualified
specialist or a specialised repair shop.
• If you have any questions, which are not answered in this manual, please
contact our technical service or an other specialist.
Image A
Image C
(4.5V/DC, min. 500 mA)
desired transmission channel
(for 3 x Mignon/AA)
The arrow in image C marks the position where the housing can be opened
by lifting it with a screw driver.
Image B
Image D
A) Bell push with LED (red)
B) Button „PLAY"
C) „Select" button
D) Dip-fix-switch to select the desired
transmission channel
E) Battery compartment (12V; type: 23A)