Installation Hints - Hama M2120 Installationshinweise

g Installation hints
Before you can install the Bluetooth mouse, be sure that
your PC/notebook supports Bluetooth technology. If it
does not, you must install an external Bluetooth receiver
and its software.
1. Hardware Installation
1.1 Inserting the batteries
a) Remove the battery compartment cover and insert
the batteries into the battery compartment . Be sure
their polarity is correct.
Connect Button
b) Replace the battery compartment cover
so that it closes securely.
c) Switch the mouse on by setting the
ON/OFF button to „ON". The battery
indicator lamp (Abb.2) lights up briefl y.
2. Connecting the Mouse (Pairing)
Start connecting the mouse (Pairing) by double-clicking
the Bluetooth icon in the taskbar with the left mouse
button (using the touchpad or another mouse).
Note: At this point, the M930 Bluetooth optical
mouse is not yet connected to the laptop.
Next click "Add" and "OK".
4
On/Off button
Fig.1
In the "Add Bluetooth Device Wizard", check the box next
to "My device is set up and ready to be found" and then
click "Next". Then briefl y press the connect button on
the bottom of the mouse.
(Fig. 1).
In the next step, select the "Bluetooth Wireless Mouse"
device and then click "Next".
Select the „Don't use a passkey" option and then click
„Next". The device is installed.
If you cannot select the option "Don't use a passkey"
(dependent on the used Bluetooth Stack/software), enter
the main passkey "0000".
In the last step, click „Finish" to complete the installation
process.