Connection; A) Connecting The Rca Inputs - Renkforce SAP-702 Bedienungsanleitung

7. Connection

Make sure that the mains plug is unplugged before connecting the device and that the volume
control VOLUME (1) is set to minimum (left stop). Before connecting the device, turn off all other
equipment to be connected to the miniature amplifier.

a) Connecting the RCA Inputs

For the connection of the RCA inputs, only use suitably shielded RCA cables. The use of other
cables might cause interferences.
To avoid distortion or mismatching that may damage the device, only sources with a RCA output
may be connected to the RCA inputs of the miniature amplifier.
You may connect devices with a LINE output level, a CD player or cassette deck, to the stereo
RCA inputs of the miniature amplifier.
These inputs are not suitable for the direct connection of a record player. In this case, you have
to switch an equalizer pre-amplifier upstream.
• The white RCA socket of the miniature amplifier is connected to the left RCA output of the respective control source
(e.g. CD player).
• The red RCA socket of the amplifier is connected to the right RCA output of the respective control source (e.g. CD
player).
AUX Connection (11)
This is where you connect the RCA output sockets of a cassette recorder, video recorder, satellite receiver, etc.
TUNER connection (12)
Connect the RCA outputs of the radio to these connections.
Connection CD (13)
Connect the RCA outputs of the CD player to these connections.
21