Oase IceFree 4 Seasons Gebrauchsanleitung Seite 13

Installing the floater
How to proceed:
 G
Push the stop plug into the opening of the floater from the top.
– Push it into the floater as far as possible.
Fit the nozzle pipe onto the stop plug protruding from the bottom of the floater.
– Do not push in all the way but leave a distance of min. 0.5 cm between the floater and the nozzle pipe.
Fitting the pump
How to proceed:
 E
Turn the union nut counter-clockwise and remove it.
Open the filter housing, remove the pump from the filter housing.
Join the supplied hoses using an adapter piece, fit the union nut on the hose, then push the hose as far as possible
onto the pump outlet.
– Shorten the hose if necessary.
Reassemble the unit in the reverse order.
– Guide the power cable through the cable duct at the bottom of the filter housing.
Pond ventilator
For summer mode, assemble the unit and set it up so that the unit generates a fountain. Install the nozzle for the de-
sired spray pattern.
N O T E
Loss of water is possible. Do not set up the unit too closely to the bank of the pond.
• Keep a minimum distance of 40 cm from the bank.
Adhere to the following conditions for dry installation:
 B
• Use a string to fasten the floater on the pond bank.
• Only operate the unit in bodies of water with a minimum depth of 40 cm.
• Do not immerse the pump as deeply as you would for winter mode (ideally approx. 40 cm deep).
Fitting the nozzle
How to proceed:
 D
Insert the nozzle in the nozzle pipe and turn clockwise to tighten.
– "Volcano" nozzle: Align the nose at the bottom of the nozzle with the groove in the nozzle pipe, then screw in
place.
Adjusting the fountain height: Turn the nozzle in/out by a few revolutions.
Installing the floater
How to proceed:
 F
Push the nozzle pipe into the opening of the floater from the top.
– Push in completely so that the nozzle pipe is flush with the floater at the top.
Take a hose and fit a hose connector on the hose end. Then fit this hose connector together with the hose on the bot-
tom of the nozzle pipe.
– Only use one hose, installing both hoses will impact the transport rate of the pump.
- EN -
13