System Requirements - SanDisk ImageMate Schnellstartanleitung

ImageMate Package Contents
• ImageMate USB or Parallel Port Flash Card Drive
• Keyboard power adapter with two cables for either AT or PS/2 keyboards
(Parallel Port version only)
• Installation CD
• Quick Installation "Getting Started" Guide
• Registration Card

System Requirements

Parallel Port ImageMate:
• Microsoft Windows 95, 98, NT, 2000
• Pentium II 200MHz or higher
• 16MB available hard drive space
• 32MB available RAM
• CD-ROM drive
• ECP or EPP compliant Parallel
Port Connector
USB ImageMate:
PC
• Microsoft Windows 98 or 2000, with
USB support
• Pentium II 200MHz or higher
• 16MB available hard drive space
• 32MB available RAM
• CD-ROM drive
• USB connector (1.0 compliant)
Macintosh
• iMac, Mac Power PC, Mac G3 or later
model
• Mac OS 8.6 or greater with USB support
• CD-ROM drive
• USB connector (1.0 compliant)
4
Parallel Port Hardware Installation
Warning: Shut down your computer and turn off its power before you install the
Parallel Port ImageMate. Failure to do so could damage your computer.
Note to USB users: Go to the next section of this guide.
1. If a printer is installed on your computer system, shut down its power and disconnect it from
your computer.
2. Connect the parallel interface cable from the ImageMate to your computer's
parallel port.
3. Attach your printer's parallel cable to the ImageMate's pass-through parallel connector.
This allows you to print without disconnecting the ImageMate from your computer.
4. Select the keyboard power adapter lead that is compatible with your PC keyboard
socket. Unplug the keyboard from your computer and attach it into the shorter end of the
Y-connector.
5. Plug the power jack (the longer end of the Y-connector) into the power input socket of the
parallel pass through connector.
6. Attach the Y-shaped keyboard connector into the keyboard jack on your PC.
7. Make sure all cable connections are secure. You're now ready to install the
ImageMate software.
5