Inhaltsverzeichnis
Werbung
Front Door
Removal/
Installation
Power Supply
Removal (FR2)
To remove the front door, firmly grasp both removal knobs and rotate them in opposite
directions. Hang on to the knobs so that as the door releases you can hold on to the
door and remove it without it falling off.
Caution!
The FR1/FR2 front fan door is heavy and is not hinged. Remove with Caution.
To remove an FR2 power supply, follow these steps:
Warning!
Ensure Mains Power is disconnected before installing the FR1 or FR2 frame R-series
modules into the frame, or installing and removing options. If a Mains switch is not
provided, the power cord(s) of this equipment provide the means of disconnection.
The socket outlet must be installed near the equipment and must be easily
accessible.
Warning!
FR2 Dual Power Cord Notice—please read this. To reduce the risk of electrical shock,
disconnect both power cords before servicing equipment.
1. Remove the frame front panel door as explained earlier.
2. Locate which of the two supplies you wish to remove. On the rear panel, remove
the strain relief screw that secures the power supply to the frame, saving the
screw.
3. From the front of the frame, grasp the two pull handles on the front of the
desired power supply and gently pull it out of the frame.
Installation of a new supply is the reverse of this removal procedure.
Grasp Supply By
Its Handle and Pull
Out
FR2 Power Supply Removal
AJA FR1 and FR2 Video Card Frames User Manual
Rear of FR2 Panel
1
Remove screw
from desired supply
Front of FR2 Panel
(Door Removed)
7
Werbung
Inhaltsverzeichnis
