Assembly - Empasa Optical Pro Bedienungsanleitung

Assembly

1
Tighten transport wheels K with screws BB and nuts
CC at bottom of housing. Tighten base plate L with
screws AA.
2
Slide reflector plate onto reflector panels. Insert one Bolt GG. Slide one washer FF over threaded end of Bolt M6x10 II and
screw on cap nut HH loosely. Repeat procedure to complete the assembly of all three sections. Fully tighten all of the bolts in
the rolled edge.
3
Assemble reflector A .Connect three reflector parts
with middle ring. Use screws GG, washers FF and cap
nuts HH.
44
V2/2018-EM-Optical