Rotate And Flip The Blades; Replace The Blades; Keep It Clean; Cleaning The Body - Worx LANDROID M Bedienungsanleitung

WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure
blade retention. Failure to use new screws could cause
serious injury.
®
The Landroid M does not cut grass like other mowers. Its Cutting
Blades (14) are razor sharp on 2 edges and spin in both directions
for maximum cutting capacity (See Fig. J). Each blade of your
®
Landroid M has 2 cutting edges. Depending on the frequency the
®
Landroid M mows your lawn, the cutting blades will need to be
rotated periodically for a new cutting edge. If your Landroid
programmed to mow the lawn every day then the cutting blades
will need to be rotated monthly for the best mowing results. Each
cutting blade will last up to 2 months when it is programmed to
mow every day. When the cutting blades are dull and worn out,
they should be replaced with the spare blades provided with your
®
Landroid M. Spare blades are also available at your nearest WORX retailer.
A. Rotate and flip the blades
®
Your Landroid M carries the Blades that are all screwed onto the Blade Turning Disc (13). The Blades allow the
®
Landroid M do its job and need care and attention. Every once in awhile, you should simultaneously rotate and flip all
blades for a perfect cut. When rotating the Blades, make sure all the Blades are adjusted at the same time or else it
could make the Blade Disc off balance. If your Landroid
last 2 months if they are rotated every month. Always check to see if the Blades are chipped or damaged and replace
them if they are.
B. Replace the blades (See Fig. K)
After some time, usually every season, your Landroid
will need to be replaced. Your Landroid
while using Blades of different age and quality. So when replacing
the Blades, make sure to replace all of them at the same time. You
can replace them with one of the five spare Blade kits and extra
Blade screws supplied with your Landroid
Before attempting to replace your Landroid
power off and put on protective gloves. Then follow these steps:
1. Gently flip the Landroid
2. Remove the battery cover and remove the battery.
3. Take the screws off the Blades with a screwdriver.
4. Firmly screw on the new Blades.
5. Refit the battery and the battery cover.
IMPORTANT: After screwing the Blade to the Blade Disc,
make sure the Blade is able to spin freely.

7.2 Keep it clean

WARNING: Before cleaning turn your Landroid
OFF. Put on protective gloves before cleaning the
Blade Turning Disc (13) and do not use running water.
(See Fig. L)
A. Cleaning the body
®
Your Landroid M will live a much happier and longer life if it is
cleaned regularly. Although, as your Landroid
machine, you will need to take care when cleaning, so DO NOT use
a hose, high pressure washers or otherwise pour running water on
®
your Landroid M, it is best to use a spray bottle filled with water.
When cleaning the machine body use a soft brush or clean cloth and
avoid using solvents or polishes (See Fig. L). Lastly, make sure that
you remove all build up of grass clippings and debris.
Lawn Mowing Robot
®
M's Blades
®
M does not like mowing
®
M.
®
M's Blades, turn the
®
M over.
®
M is an electric
®
M is
J
®
M mows on a normal schedule (daily) then the Blades should
K
®
M
L
1
2
EN
13