Operation Instructions:
The remote control is infra-red controller
Please refer to Safety Precautions and Installation Instruction. Mount the hea-
1.
ter in position. After fixing the heater and ensuring the correctness of the con-
nection, connect the heater with power. Input rated current of heater supplied
by the power outlet shall be above 10A.
Heater Functions
2.
Function keys on the panel
1.
ON/OFF
2.
Power I/II/III
+ Key
3.
Temperature setting
4.
Timing settings
5.
6.
- Key
•
Working temperature: -9—35, setup scope: 15—35, LED display; When in use,
LED display for gear, heating indicator, temperature and timer.
Set the three-gear heating mode: high heat power mode, mid heat power
•
mode, low heat power mode and shut-down mode in a cycle.
•
Auto shut-down timer function: hourly increment or decrement, maximum 24
hours.
•
Heating temperature select from 15 to 35: automatic heating and automatic
temperature control function is activated after the selection of temperature.
•
If there's no operation after the selection of function, LED dims out after 10
seconds.
3. Working Process of the Heater
•
Switch on: Turn on the mechanical power-on switch on the side of the panel.
The temperature icon
the right side of the temperature icon represents the current ambient tempe-
rature. Under such condition, the heater enters standby state.
•
First pressing on the (ON/OFF) key to start the heater. Meanwhile, the heater
enters operation mode and the low heat power icon
tes that the heater is operating in low heat gear; press the Power key again
°C
will be shown on the display panel. The number on
6
are on, which indica-