Glaziar Vesubio Betriebsanleitung Seite 5

WARNING: This heater is not equipped with a device to control the room
29.
temperature. Do not use this heater in small rooms when they are occupied
by persons not capable of leaving the room on their own, unless constant
supervision is provided.
Footboard installation instructions:
Remove the feet with casters and heater body, the heater body on the soft cloth
or other soft material above, and then put the foot on the side of the bottom of
the body, with the screws in the package tighten.
Instructions:
1. Power Select
Represents low gear.
Represents mid gear.
and Also shown as high gear.
°C
Represents temperature setup, adjustable range: from 15 to 35.
Represents timer setup, which offers power-on and power-off timer function
with a time period from 1 hour to 24 hours.
2. Temperature Setup Function
Every time when the heater is switched on, it displays indoor ambient tempe-
rature. During the heating state, the working temperature can be set. When the
ambient temperature reaches the preset value, the heater stops working, and
will not resume work until the ambient temperature drops below the pre-set
value. The working temperature ranges from -9 to 35 and temperature setup
scope is from 15 to 35.
3. Auto Power-on and Shut-down Timer Function
Auto power-on and shut-down timer function is available. The setting time ran-
ges from 1h to 24h. The setting can be in cycle with an increment of 1h. When
the heater is in the working state, auto shut-down timer can be set. When the
heater is in the standby state, auto power-on timer can be set. In the timer state,
the icon glitters and the number on its right side displays the remaining time.
4. Memory Function
Every time the heater is switched on (provided that the power has not been di-
sconnected), the heater can recall the last set temperature and work according
to the setting value. If disconnecting with the power supply, the heater's setup
values will be reset to ex-works setting when switched on next time.
5