Flushing The Machine Before First Use - Philips Senseo Twist HD7873 Benutzerhandbuch

To flush the filter cartridge, hold the filter
4
holder over a sink and fill it with cold tap
water. Let the water flow through the filter
cartridge and discard the water. Then repeat
this process once more.
Place the filter cartridge holder in the water
5
reservoir.
The BRITA MAXTRA filter cartridge should
6
be replaced every 2 months. To remind you
when to replace the filter cartridge, turn the
lid upside down (1). Set the dial in the bottom
of the lid to the month in which you replaced
the filter cartridge (2).
In the top of the lid, the filter cartridge
7
replacement indicator shows the month in
which you need to replace the filter cartridge
again.
5 Flushing the
machine before first
use
It is important that you flush your SENSEO
coffee machine before first use. After the flushing
cycle (which only takes approx. 2 minutes), the
machine is ready for brewing SENSEO
C
Caution:
Never interrupt the flushing cycle halfway. If you
do, the boiler does not fill itself properly.
Attach the spout to the machine. Grab the
1
two ridges of the inner part of the spout and
squeeze them lightly (1). Place the spout on
the machine and release the two ridges (2).
C
Caution:
Never flush the machine or let it brew coffee
when the spout is not in place.
Tilt the top of the water reservoir backwards
2
(1) and lift the water reservoir off the
machine (2).
®
® coffee.
9