Operation - GreenWorks Tools G40LT Bedienungsanleitung

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
ATTACHING GRASS DEFLECTOR See Figure 2.
The line cut-off blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
„ Invert the string trimmer to access the trimmer head.
„ Place the guard (2) on to the trimmer head.
„ Align the screw holes on the guard with the screw holes
on the trimmer head.
„ Insert the screws into the trimmer head, fastening the
guard in place using a philips head screwdriver (not
included).
SHAFT ASSEMBLY See Figure 3.
The attachment connects to the power head by means of
a coupler device.
„ Set the unit on a flat, level surface.
„ Loosen the knob (1) on the coupler (5).
„ Push in the release button (2) located on the lower
shaft (3). Align the release button with the positioning
hole (4) and slide the two shafts together. Rotate the
lower shaft until the button locks into the positioning
hole.
„ Tighten the knob securely.
NOTE: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked
into place.
ATTACHING THE AUXILIARY HANDLE See Figure 4.
„ Press the auxiliary handle (1) onto the upper shaft so
that the handle is angled toward the rear handle that
allows for comfortable operation.
„ Slide the auxiliary handle over the metal ring (2) and
ensure the metal ring fits between the slot on the
auxiliary handle.
„ Align the holes on the auxiliary handle with the holes
on metal ring.
„ Insert the handle knob (3) through the auxiliary handle.
„ Tighten until there is no movement in the handle.
English (original instructions)
WARNING

OPERATION

Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting in
possible serious injury.
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger models.
NOTE: To avoid serious personal injury, always remove
the battery pack and keep hands clear of the lock-out
button when carrying or transporting the tool.
TO INSTALL BATTERY PACK See Figure 5.
„ Place the battery pack in the trimmer. Align raised
ribs (3) on battery pack with grooves in the trimmer's
battery port.
„ Make sure the latch on the back of the battery pack
clicks into place and that battery pack is fully seated
and secure in the trimmer before beginning operation.
TO REMOVE BATTERY PACK See Figure 5.
„ Release the switch trigger and lock-out trigger to stop
the trimmer.
„ Press and hold the battery latch button (1) on the back
of the battery pack.
„ While holding the battery latch place one hand the the
trimmer handle (2) and remove battery pack.
STARTING/STOPPING THE TRIMMER See Figure 6.
„ Ensure a fully charged battery is installed into the string
trimmer.
„ To start the string trimmer, press and hold the lock-out
button (1) and squeeze the switch trigger (2).
2
WARNING
WARNING
WARNING