Kärcher WRP 10000 Betriebsanleitung Seite 19

Time Activity Assembly af-
fected
daily opinion Indicator lamps
"Error"
Indicator lamp
"Fresh water
supply was ac-
tive"
weekly Clean the Drain at wash-
filter ing place
opinion Recycling water Check recycled water for odour and turbidity. See section on "troubleshoot-
Detergent con-
centration in re-
cycled water
Gravel filter
monthly opinion Swimmer switch Check settings and status of the float sensors; inform Customer Service, if re-
Backwash clock Does the backwash clock show the correct time? Is the desired backwash
Sludge collec-
tion, pump ba-
sin
empty, Recycled water
clean tank
half-yearly Check the Gravel filter
gravel, re-
place if re-
quired
opinion Backwashing
Check Ventilation
through-
flow quan-
Immersion
tity
pump
Float sensor level
S7 up
S7 bottom
S9 top
S9 bottom
S11 top
S11 bottom
Maintenance schedule
Performance
When this indicator lamp lights up, solve the problems according to instruc-
tions in the "Troubleshooting" section
Press the illuminated key "acknowledge message", find the cause for the
fresh water use and alleviate it.
Clean the dirt collection basket in the floor.
ing" for measures against poor quality of recycled water.
Check the detergent dose at the washing unit if there is too much foam for-
mation.
Check filtering capacity. As long as the washing unit draws waterwater, the
water level in the recycled water tank must not fall below the starting level S9.
Trigger the manual backwash or change gravel if capacity is too low.
Danger
Health hazard due to dust and microbial pollutants. Wear face masks and
gloves while changing the gravel.
quired.
time set correctly?
After sludge has been collected, there should be no sludge in any of the ba-
sins. The sludge in the sludge collector should be maximum 1 m in height.
Check sludge level; pump out and dispose of the sludge, if required. Clean
the basin.
Empty, clean, rinse and refill.
Danger
Health hazard due to dust and microbial pollutants. Wear face masks and
gloves while changing the gravel.
Replace gravel if necessary; while doing so, clean upper and lower filter sieve
(rinse off with water).
Does enough water flow from the pipe to the sludge trap during backwash-
ing? Check pressure.
If the ventilation is running, bubbles are visible in the pump basin.
The flow rate is correct if the water level in the processed water tank does not
fall below level S7 when the washing unit is being operated.
Fill capacity recycled water 1
tank
960 l
810 l
550 l
410 l
450 l
210 l
EN
Fill capacity recycled water 2
tanks
1,920 l
1,620 l
1100
820 l
900 l
420 l
7
-
By whom
Operator
Operator/
Customer
Service
Operator
Operator
Operator
Operator
Customer
Service
Operator
Customer
Service
Operator
Operator
Customer
Service
Customer
Service
Customer
Service
Customer
Service
Fill capacity recycled water 3
tanks
2,880 l
2,430 l
1,650 l
1,230 l
1,350 l
630 l
19