Defrosting Of The Freezer - Electrolux EJ2300AOW Benutzerinformation

• Be careful not to pull, move or
to cause damage to the pipes
or the cables.
• Be careful not to cause damage
to the cooling unit.
• Do not clean the appliance with
abrasive products, abrasive
cleaning pads, solvents, deter-
gents with perfume or wax pol-
ish.
6.2 Automatic defrosting of the fridge

6.3 Defrosting of the freezer

There can be frost on the freezer
shelves and around the top com-
partment.
Defrost the freezer when the layer
of frost has a thickness of 3 or 5
mm.
CAUTION!
Do not use sharp metal tools to
remove the frost.
Do not use mechanical devices to
defrost the freezer.
1. Deactivate the appliance.
2. Remove all the food from the freezer.
Wrap the food in newspaper and keep
it at a cold temperature.
3. Keep the appliance door open until
defrosting is completed.
4. Clean and fully dry the freezer.
After maintenance, connect the mains
plug to the mains socket.
The removal of frost occurs automatically
when the motor compressor stops during
operation.
The water drains out through the drain
hole and collects in the water container
where it evaporates.
The water container is behind the appli-
ance, above the motor compressor.
The drain hole is in the fridge on the rear
part.
To prevent water to collect in other parts
of the fridge, make sure that the drain
hole is always clean. Use the cleaning tool
that is in the drain hole.
5. Connect the mains plug to the mains
socket.
6. Activate the appliance.
7. Set the temperature knob at the high-
est position and let the appliance op-
erate for 2 or 3 hours with this setting.
8. Put back the food in the freezer.
6.4 When the appliance is not
used for long periods
1. Deactivate the appliance and discon-
nect the mains plug from the mains
socket.
2. Remove all the food.
3. Defrost the appliance.
4. Fully clean and dry the appliance and
all the accessories.
5. Keep the doors open to prevent un-
pleasant smells.
ENGLISH 21