Compact Call Set
6.2
Wall installation of compact call set (Part No. 76910C1 / 76910D1)
The components of the compact call set are installed within a flush wall box and can optionally be
supplemented by a sealing kit for standard installation units.
1
Fig. 6: Installation sequence (example with cancel button)
Flush wall box Ø 60 mm (installation depth at least 44 mm)
Seal for installation unit (sealing kit for standard installation units)
Installation unit
Seal for frame (sealing kit for standard installation units)
Cover plate frame
Seal for cover plate (sealing kit for standard installation units)
Cover plate for duty room unit, pull switch, electronic module (Part No. 72585B)
1. Install the flush wall box in the wall and ensure a sufficient reserve of cable.
2. Position the seal and installation unit , then fasten with the four enclosed screws.
3. Mount the seal , cover plate frame , seal and cover plate (depending on the module used) with
the correct orientation.
Sealing kit for standard installation units (Part No. 88160A)
The sealing kit increases the component protection class from IP 40 to IP 44.
Note different installation of the electronic module (Part No. 72570P1)!
20
2
3
4
5
6
7
Possible cover plates
Components of the wet room for
optional installation of the sealing
kit
76910XE / 02.2018