Battery Operation; Coding; Chime Selection - REV 14902 Bedienungsanleitung

Protection type: Receiver IP20 – only suitable for use indoors
Transmitter - suitable for sheltered outdoor use
Transmission radiation takes place within the milliwatt range
for just a few milliseconds when the transmitter is activated and is
not dangerous to health.
Hereby REV Ritter GmbH declares that model/serial 14902
& 04444R2 conforms to the basic requirements and remaining,
applicable provisions of Directive 1999/5/EC . Please see below
for a complete CE conformity declaration: www.rev.biz under the
relevant item.

3. Battery operation

Remove the cover from the battery compartments 1 + 2 and insert
the specified batteries – pay attention to correct polarity (+/-).
Safety instructions for batteries:
• I nserting the batteries the wrong way round (incorrect +/-
polarity) can damage/destroy the appliance.
• D o not store batteries within the reach of children. This applies in
particular to batteries that could be swallowed.
• S eek immediate medical help for affected person in the event of a
battery being swallowed.
• D o not attempt to revive batteries by heating up or similar
measures. Primary batteries may not be recharged as this can re-
sult in electrolyte leakage, fire and explosions.
16
• D o not immerse batteries in water and do not store in a damp
place. Always store in a dry and cool place.
• D o not throw batteries into fire. Do not attempt to open, solder or
weld.
• D o not short-circuit batteries.
Please dispose of batteries in compliance with legal requirements
(see section no. 14)

4. Coding

The transmitter  and receiver  must be assigned the same code
first before you can operate the receiver  by remote control. 16
different coding possibilities are available to ensure that the receiver
reacts without fail to the transmitter's signals. Open the cover of the
battery compartment on the transmitter
a position between 1 and 16 chosen by you. The switch
receiver A has to be set the same position.
TIP: T est the required function before final installation at your chosen
installation point (see text no. 10).

5. Chime selection

You can set required chime using the selector switch
(a) 2-tone chimes
(b) 3-tone chimes
(c) Westminster chimes
TIP: If you are using further transmitters you can install differing
signals using chime selection.
and turn the switch to
➁ ➂
on the
➂
:
➃
17