Unpacking And Setting Up; Setting Up The Appliance; Operation; Switching The Appliance On And Off - Silvercrest SOR 600 A1 Bedienungsanleitung

RP90854 Ölradiator LB6 Seite 7 Mittwoch, 17. Juli 2013 4:15 16
the appliance as directed in section
"8. Disposal" on page 8.

5.1 Setting up the appliance

Note: Because the supplied appliance and
its heating coils are coated with a thin film of
grease, you may notice a small amount of
smoke and odour the first time it is used. This
is not harmful and will stop after a short
while. Ensure adequate ventilation during
this time.
1. Take the appliance out of its packaging.
2. Remove the transport packaging.
3. Check that the appliance has not
sustained any damage.
4. From underneath, slide the rear foot 6
completely onto
element 3.
5. From the front, slide the front foot 7 onto
the corresponding receptacle and push
it in until it latches into place.

6.1 Switching the appliance on and off

1. Switch the appliance on by turning the
control knob 4 until you hear a click and
see the indicator lamp 5 light up.
The thermostat is now set to the current
room temperature.
The heater will switch on and off
alternately in order to maintain the
current temperature setting. Whenever it
is heating up the indicator lamp 5 will
come on.
SOR 600 A1

5. Unpacking and setting up

6. Check that the appliance stands
7. Select a location in line with the safety
8. Check that the control knob 4 is set to
the last heating
9. Insert the mains plug into a power

6. Operation

2. If you want a higher room temperature,
3. If you want a lower temperature, turn the
4. To switch the appliance off, turn the
steadily.
Warning!
– Ensure that it is located suffi-
ciently far from walls, fixtures
and other appliances. The dis-
tance must be at least 0.5 m to
exclude the risk of fire.
– The appliance may be operated
only when upright.
instructions (see "4. Safety information"
on page 4).
"OFF".
supply socket that meets the technical
data requirements (see "3. Technical
data" on page 4).
turn the control knob 4 further towards
"MAX".
control knob 4 in the opposite direction
somewhat.
control knob 4 to "OFF".
7