Replacing The Filter; Replacing The Batteries; Cleaning And Maintenance - Waeco Multi Gas Bedienungsanleitung

Multi-Gas-O-12s.book Seite 22 Freitag, 25. Mai 2018 1:42 13

Replacing the filter

9 Replacing the filter
!
CAUTION! Beware of burns
Switch off the leak detector and let the sensor head cool down
before replacing the filter.
I
NOTE
Replace the filter if it is blocked or dirty.
➤ Unscrew the sensor cap (fig. 3 1, page 3) anticlockwise from the sensor
head.
➤ Take out the filter (fig. 3 2, page 3) with tweezers or needle-nose pliers.
➤ Insert a new filter.
➤ Screw the sensor cap (fig. 3 1, page 3) clockwise onto the sensor head.
10

Replacing the batteries

➤ Replace the batteries when the green LED (fig. 2 3, page 2) does not
light up.
➤ Gently push down the lid of the battery compartment on the back and slide
it open in the direction of the arrow.
➤ Insert the new batteries (3 x type C) in the battery compartment. Make
sure the polarity of the batteries is correct.
➤ Close the lid of the battery compartment.
11

Cleaning and maintenance

A
NOTICE!
 Do not use sharp or hard objects or cleaning agents for
cleaning as these may damage the product.
 Do not clean the sensor with water.
➤ Occasionally clean the product with a damp cloth.
22
Multi Gas
EN