Bosch BLE 130 Professional Bedienungsanleitung Seite 19

OBJ_BUCH-136-002.book Page 19 Tuesday, June 5, 2007 9:02 AM
Operating Instructions
Marking
The height of the laser beam can be marked at the centre mark 7 on the
right and left of the measuring tool when it runs through the centre of the
reception area 6. The centre mark is 50 mm away from the upper edge of
the measuring tool.
Aligning with the Spirit Level
The measuring tool can be aligned vertically (plumb line) with the spirit level
1. A measuring tool applied out-of-level leads to faulty measurements.
Attaching with the Holder (see figure A)
With the holder 14, the measuring tool can be fastened to a construction
laser measuring rod 16 (accessory) as well as to other auxiliary tools with
a width of approx. 5 to 50 mm.
Slide the holder 14 sidewards into the retainer openings 8 on the rear side
of the measuring tool until it can be heard to latch.
Loosen the locking screw 17, slide the holder onto the construction laser
measuring rod 16, for example, and retighten the locking screw 17.
The upper edge 15 of the holder is located at the same height as the centre
mark 7 and can be used for marking of the laser beam.
To remove the measuring tool from the holder 14, press the holder latch 13
and pull the measuring tool out of the holder.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the measuring
tool can be attached to steel parts via the face and rear side using the mag-
net plate 12.
English | 19
1 609 929 L47 • 5.6.07