Specifications - GreenWorks 2400407 Bedienungsanleitung

SPECIFICATIONS

Product Specifications
Type
Motor
Air Velocity
Weight (Battery
Pack not included)
Battery Pack
Charger
Sound pressure
level
Sound power level
Vibration level
DESCRIPTION
1. Battery Release Button
2. Trigger
3. ON/OFF Button
4. Speed Selection Button
5. Blower tube
6. 82V Lithium-lon battery
7. Unlock
8. Lock
9. Lock Position
ASSEMBLY
UNPACKING
■ Carefully remove the product and any accessories
from the box.
■ Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call your
Greenworks Tools service centre for assistance.
Do not use this product if any parts on the packing list
are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
English (original instructions)
2400407
80 Volt DC
200 km/h (Max)
2.7kg
2914907 / 2914607/2914507
2914707
L pA : 88dB(A) k: 3 dB(A)
LWA: 96.2dB(A)
K：3.0dB(A)
Ah: 2.5m/s 2 , k:1.5m/s 2
(See Figure 1)
WARNING
ASSEMBLING THE BLOWER TUBE See Figure 2.
To prevent accidental starting that could cause serious
personal injury, always remove the batterypack from
the tool when assembling parts.
■ Align either of the grooves in the tube with the tabs
on the blower housing. Push the tube onto the blower
housing until the tab engages the grooves (Fig. 2).
■ Turn the tube in the direction of the arrow until both of
the tabs slide into the lock positions (Fig. 3).
For complete charging instructions, refer to the
Operator's Manuals for your battery pack and
charger models.
NOTE: To avoid serious personal injury, always remove
the battery pack and keep hands clear of the variable
speed trigger when carrying or transporting the tool.
TO INSTALL/REMOVE BATTERY PACK See Figure 4.
TO INSTALL
■ Align the ribs of the battery pack with the mounting
slots in the blower's battery port.
■ Insert the battery into the battery opening until the
battery release button locks into place.
When placing battery pack in the blower, be sure the
raised ribs on the battery pack align with the grooves
in the top of the blower. Make sure the battery is fully
seated, and it latches into place properly. Improper
installation of the battery pack can cause damage to
internal components.
TO REMOVE BATTERY PACK
■ Press the battery release button on the blower. This
will cause the battery to slightly protrude out of the
tool.
■ Grasp the blower firmly and pull the battery out of the
handle.
Always take care of your feet, children, or pets around
you when pressing the battery release button. Serious
injury could result if the battery pack falls. NEVER
remove the battery pack when in a high location.
13
WARNING
CAUTION
WARNING