Maintenance; Troubleshooting - AIRELEC PARIS Bedienungsanleitung

2. If « FF » is displayed, a modification is impossible
(if temperature delta is more than 3° C or the
comfort temperature setting is under 17° C or over
23° C).
Note: Without any action on + or - for 15 seconds, the display
returns on its initial position (19).
To maintain the performance of the heater, it is necessary to regularly remove dust inside the
appliance by vacuuming the front grid.
To remove outside dust, use a soft cloth. To remove a stain, moisten the cloth. Never use abrasives
that can damage the various coatings.
NEVER USE ABRASIVE OR ACETONE WHICH COULD DAMAGE THE EPOXY NEVER USE ABRASIVE OR ACETONE WHICH COULD DAMAGE THE EPOXY
NEVER USE ABRASIVE OR ACETONE WHICH COULD DAMAGE THE EPOXY NEVER USE ABRASIVE OR ACETONE WHICH COULD DAMAGE THE EPOXY
COATING! COATING!
COATING! COATING!
ALL INTERVENTIONS ON OUR APPLI ALL INTERVENTIONS ON OUR ALL INTERVENTIONS ON OUR ALL INTERVENTIONS ON OUR
BY A QUALIFIED AND LICENSED PROFESSIONAL. BY A QUALIFIED AND LICENSED PROFESSIONAL.
BY A QUALIFIED AND LICENSED PROFESSIONAL. BY A QUALIFIED AND LICENSED PROFESSIONAL.
SUGGESTIONS:
Children should be monitored in order to avoid them to play with the heater.
Do not insert anything into the device.
When switched on for the first time, a smelling can be noticed, this phenomenon disappears after a
few minutes of operation.
If your device is connected to a load-shedding network: When load shedding is set as a priority, it is
possible that the heater does not work, in case of momentary over-consumption (washing machine +
oven + iron). This is normal. Upon restoration of normal consumption, the unit will re-heat.
This heater is intended to be connected to a mains supply of 230V 50Hz. This device is not intended
to be used by persons (including children) with physical, sensory or mental disability, or persons
lacking experience or knowledge, unless they are supervised or have been instructed by a person
responsible for their safety.
The appliance is not heating:
Ensure that the power installation is connected properly ; on the heater itself as well as on the
• • • •
main board and that the load shedding device (if any) does not cut off power supply.
The heater does not follow the programming instructions:
Make sure that you use the programming unit as intended (see its manual).
• • • •
The appliance is heating permanently:
Verify that the device is not located in an air current or the temperature setting has not been
• • • •
changed.
In case of a thermostat problem, cut the power (fuse, circuit breaker) for about 5 minutes and
• • • •
restart the device.
If the problem occurs frequently, check with your energy supplier. In all other cases please
contact a qualified technician.
At the first use, a light smell related to the normal evacuation process on the heating
element may occur.

6. MAINTENANCE

APPLIANCES APPLI APPLI ANCES MUST BE CARRIED OUT ANCES ANCES MUST BE CARRIED OUT OFF MUST BE CARRIED OUT MUST BE CARRIED OUT
7. TROUBLE SHOOTING
=English Version=
OFF TENSION OFF OFF TENSION TENSION TENSION
16