Selecting The Wire Type In The Temp Mode - asmodus MINIKIN 155W BOOST Bedienungsanleitung

Using the Device
Selecting the Operation Mode
Access the Mode menu by pressing the Fire button rapidly 6 times while the device is switched on so that
SEL
"MODE SEL" appears on the display. Press the "+" or "-" button to select the PWR, CURVE, TEMP, TCR and
TFR operating modes. Confirm your selection by pressing the Fire button.

Selecting the Wire Type in the TEMP Mode

In the TEMP submenu, press the "+" or "-" button to select the atomizer head's coil type as being Ni200,
SS304, SS316, SS317, SS340, or Ti. Confirm your selection by pressing the Fire button.
Settings in CURVE Mode
In the CURVE submenu, press the "+" or "-" button to set the power value. Press the Fire button and set the time by
pressing the "+" or "-" button. Pressing the Fire button will take you to the next point where you can define the power
curve. There are a total of 5 curve points where you can set the parameters of power (in watts) and time (in seconds).
The power value refers to the output power when first using the device and the time value refers to the duration of the
output power defined in the respective curve point. Press and hold the Fire button to confirm your entry.
41