JiaYuan sky spy Bedienungsanleitung Seite 7

13. READING THE AERIAL PHOTOGRAPHY DATA & CHARGING
14. REAL TIME AUDIO & VIDEO DURING FLIGHT
1
Fix the video transmitter on the tail boom and
then insert the 2.5mm plug into the AV output jack
of the aerial camera. Switch on the camera. This
time the red LED on the video transmitter will be
ON, meaning it has started working.
3
The DIP switches on the back of the transmitter
are for setting the receiving frequency. Ensure
you match the receiving and transmitting
frequencies. If the transmitter is set to Channel
A, then so too must the receiver.
Should you be unable to receive any real-time video, please consult the following list
1) Check if the 2.5mm video transmitter plug has been inserted into the AV output jack on the aerial
camera.
2) Check if the red LED on the transmitter is ON or not. If it is not ON, it means the plug is not
connected correctly in the AV port. Unplug and then re-connect. Should the problem not be
solved by this, then the aerial camera could have insuficient power, in which case it will need
charging.
3) Check if the transmitting frequency on the video transmitter is the same as the receiving frequency.
4) If unable to receive any images, this may be due to the DIP switch having been set
incorrectly.
Disconnect the included USB cable from the helicopter and connect
to a standard USB port on a PC. In a moment you can ind the new
"removable disc" in the "My Computer" directory. Double click it to
read the data inside the aerial camera. Please copy the aerial
photography data from the disk to the computer and then browse to
it. When the data has inished copying, please do not remove it from
the USB port immediately as the USB port also charges the camera.
When charging is underway, the LED indicator on the camera will
lash and then glow solidly when the camera is fully charged.
.
ON ON ON
1 2 3 4 1 2 3 4 1 2 3 4
A channel B channel C channel D channel
2
Push up and down the DIP switch on the
transmitter to set the frequency. For this
helicopter, there are four transmitting frequencies
available. Set the DIP switch as shown in the
illustration.
4
ON
Switch ON the
1 2 3 4
transmitter's power
switch. If the
transmitting frequency
is the same as the
receiving frequency the
screen will show a real-time image. Please
press the ON/OFF button to switch OFF the
display screen in order to save power when
you do not wish to have any live video image
shown.
7
ON ON
ON
1 2 3 4
1 2 3 4 1 2 3 4
A channel B channel C channel D channel
LCD Power
Switch
ON
ON
1 2 3 4
1 2 3 4